Threads, torque and grease 8.01
Torque settings
Most bike bolts have a number printed next to them, like 5 Nm. That's how tight they should be. Too loose and parts slip or rattle, too tight and you crack carbon or strip threads. A small torque wrench takes the guessing out of it.
Get the printable PDFDoing it right
Torque wrench
Set the number, then pull smoothly until it clicks. Stop at the click.
Crosswise
Faceplates and clamps with several bolts: a little at a time, crosswise, keeping the gaps even.
Carbon paste
On carbon parts, carbon assembly paste lets them grip at a lower torque.
Reading the numbers
- Look on the part first. The torque is usually printed next to the bolt, like "5 Nm max" or "4-6 Nm".
- Use the lowest number that works on carbon. Go up only if it slips, and never past the maximum.
- Two parts, two numbers? Use the lower one. A carbon bar in an alloy stem: the bar's number.
- No number anywhere? Check the maker's manual online, then use the typical figures over the page.
Typical torques
| Part | Typical | Check |
|---|---|---|
| Stem faceplate and steerer bolts | 5 Nm | Printed on the stem |
| Seat clamp | 5 to 6 Nm | Less on carbon posts |
| Brake caliper bolts | 6 to 8 Nm | Brake maker's manual |
| Rotor bolts, 6-bolt | SRAM 6.2, Shimano 2 to 4 Nm | Rotor maker |
| Centerlock lockring | 40 Nm | Printed on the lockring |
| Cassette lockring | about 40 Nm | Printed on the lockring |
| Shimano crank pinch bolts | 12 to 14 Nm | Do them up in turn |
| Pedals | 35 to 55 Nm (Shimano) | Crank maker on carbon |
| Bottle cage bolts | about 4 Nm | Easy to strip |
Typical figures from makers' manuals and Park Tool. The number on your part always wins.
Things that catch people out
- Grease changes the torque. Grease threads unless the maker says threadlock, and use their number.
- Don't use a torque wrench to undo bolts. It upsets the calibration.
- Small bolts strip easily. 4 to 5 Nm is not much: two fingers on a short Allen key.
- Check bolts again after the first ride on new parts. Some settle in.
Tools
- Torque wrench, about 2 to 15 Nm
- Bit set to suit
- Carbon assembly paste
- Grease
From the workshop
A small torque wrench is the second tool I'd buy after a pump. Carbon bars, posts and steerers can crack if they're overtightened, and that's an expensive mistake to make for the sake of a tool.
Michael
Book it inGet the printable PDF
The same guide on two A4 pages, to print for the workshop or keep on your phone. Leave your email and we'll send the link. It unlocks every guide in the library on that device.
Already unlocked on this device? Download the PDF
This guide is general advice for home mechanics. Bikes and parts vary, so always follow the maker's instructions and torque settings for your parts. If you're not sure, or the job needs tools you don't have, ask a qualified mechanic. Travers Bikes can't be responsible for work you carry out yourself. Nothing here affects your legal rights. Sizes checked 17/11/2026 against makers' torque figures and Park Tool's torque table.