Skip to content

Tyres and tubes 4.04

Tyre pressure

Tyre pressure is the cheapest change you can make to how a bike rides. Too hard and it bounces off every bump, too soft and it squirms or pinch flats. Here's how pressure carries your weight, where to start, and how to find the number that suits you.

Get the printable PDF
contact patchyour weight on this wheelabout 55 to 60% of it on the rearthe tyre squashes about 15%of its height at the right pressureair pressurerim internal widthtyrewidthwider tyre, wider patch, less air needed
The air in the tyre holds you up. The tyre squashes onto the ground until the patch is big enough to carry the weight. Drawing not to scale.

The same tyre at three pressures

61small patch, tall and tight

Too hard

A small contact patch. Fast on smooth tarmac, but it skips over bumps, loses grip and shakes you about.

57longer patch, sidewalls just bulge

About right

The tyre squashes a little and the sidewalls just bulge. Grip and comfort, without feeling vague.

48rim close to the ground

Too soft

The tyre folds in corners and the rim gets close to the ground. Rim dents and, with a tube, pinch flats.

Finding your pressure

  1. Weigh yourself with the bike and your kit, everything you'll ride with. That's the number that matters, not your weight on its own.
  2. Get a starting point from the table over the page or the calculator at traversbikes.com/tyre-pressure. Run the front a few psi lower than the rear.
  3. Pump up with a gauge you trust and check before every ride. Tubeless tyres seep air over a few days and tubes lose it faster than you'd think.
  4. Then fine-tune on your usual ride. Drop 1 to 2 psi at a time until the tyre feels vague in corners, then go back up one step. Write the numbers down.

Starting pressures, tubeless

Front / rear in psi for the weight of rider, bike and kit together. From our own calculator, on the tyre and rim shown.

Riding (tyre on rim, surface)65 kg80 kg95 kg110 kg
Road, 28 mm on 21 mm, smooth tarmac50 / 5562 / 6774 / 8085 / 92
Gravel, 40 mm on 24 mm, gravel road26 / 2932 / 3538 / 4244 / 48
Mountain XC, 2.25 in on 28 mm, trail18 / 20.522.5 / 25.526.5 / 3030.5 / 35
Trail and enduro, 2.4 in on 30 mm, trail15.5 / 1819 / 2223 / 2626.5 / 30
Fat bike, 4.0 in on 80 mm, trail7 / 7.58.5 / 910 / 1111.5 / 12.5
E-bike, 2.4 in on 30 mm, trail16 / 18.520 / 22.523.5 / 2727.5 / 31

1 bar is 14.5 psi. Never go over the maximum on the tyre sidewall or the rim, whichever is lower.

What moves the number

ChangePressure
Inner tubes, not tubelessabout 18% more
Rough or patched tarmacabout 5% less
Gravel roadabout 11% less
Loose gravel, dirt or mudabout 16% less
Tough, reinforced casingabout 6% more
1 mm wider rim, road or gravel2 to 3% less

Tools

  • Track pump with a gauge
  • Digital pressure gauge (more accurate than most pump gauges)
  • Mini pump or CO2 for the ride
  • Presta to Schrader adaptor

Things that catch people out

  • The number on the sidewall is a maximum, not a target. Most riders are happiest well below it.
  • Hookless rims have lower limits. Usually 72.5 psi (5 bar) on road and gravel, and 30 psi (about 2 bar) on mountain bike rims. Check your rim maker's figure.
  • Pump gauges can be well out. Two pumps can read several psi apart. Use the same gauge every time, or a separate digital one.
  • Wider tyres need much less air. Going from a 25 to a 32 mm road tyre can take 15 psi or more off what you need.
  • Front and rear aren't the same. More of your weight sits on the rear, so the front usually runs a few psi lower.

From the workshop

Get a decent gauge, find your starting number with the calculator, then spend a ride or two playing with it. Once you've found the pressures you like, write them on a bit of tape on your pump so you're not guessing next time.

Michael

Book it in

Get the printable PDF

The same guide on two A4 pages, to print for the workshop or keep on your phone. Leave your email and we'll send the link. It unlocks every guide in the library on that device.

We'll email you a link. It unlocks every guide on that device.

Already unlocked on this device? Download the PDF

This guide is general advice for home mechanics. Bikes and parts vary, so always follow the maker's instructions and torque settings for your parts. If you're not sure, or the job needs tools you don't have, ask a qualified mechanic. Travers Bikes can't be responsible for work you carry out yourself. Nothing here affects your legal rights. Sizes checked 17/11/2026 against our own tyre pressure calculator and the ETRTO hookless rim limits.

BookMy Shed