Wheels 3.06
Spoke length
Every wheel build starts with the right spoke lengths, and they come from four numbers: two from the rim and hub makers' spec sheets, one you choose and one you can measure. Get one wrong by a millimetre and the wheel won't build properly.
Get the printable PDFMeasuring them yourself
ERD
Two spokes with nipples in, across the rim. Measure the ends and add the bits sticking out.
Flange diameter
Across the centres of two opposite spoke holes, not the outside of the flange.
Centre to flange
From the middle of the hub to each flange. Left and right are usually different.
Getting the lengths
- Check the makers' spec sheets first. Rim makers list the ERD, hub makers the flange diameters and centre to flange for each side.
- Choose the lacing. 3-cross for most 28 and 32 hole wheels. Radial only where the maker allows it.
- Put the numbers into a calculator, ours at traversbikes.com/spoke-calculator has most Nextie rims and many hubs built in.
- Round to the nearest mm. Between two sizes, go for the shorter one. Rear and disc wheels need a length for each side.
The numbers
| Name | What it is | Where it comes from |
|---|---|---|
| ERD | Effective rim diameter: where the spoke ends sit inside the rim | Rim maker's spec, or measure it |
| Flange diameter | Across the centres of the spoke holes | Hub maker's spec |
| Centre to flange | Middle of the hub to each flange | Hub maker's spec, each side |
| Spoke holes | 28, 32, 36 and so on | Rim and hub must match |
| Crosses | How many spokes each one crosses | Your choice: 3-cross is usual |
| Spoke offset | Holes off centre in some rims | Rim spec; Nextie ones are built into our calculator |
Rounding
| Worked out | Order |
|---|---|
| 290.6 mm | 291 mm |
| 289.9 mm | 290 mm |
| 290.5 mm | 290 mm |
Between two sizes, the shorter one.
Tools
- Vernier callipers
- Two spokes and nipples, for the ERD
- Spoke ruler
- The rim and hub makers' spec sheets
Things that catch people out
- Flange diameter is not the outside of the flange. It's across the hole centres, so it's smaller.
- Calculators differ slightly. Use the same one each time, and check its ERD means the same as the rim maker's.
- Washers under the nipples change the length on some alloy rims.
- Straight pull hubs use straight pull spokes, and the maker's own numbers.
From the workshop
I build every wheel from these four numbers, and I still check them against the makers' spec sheets before I cut or order a spoke. If you'd rather I did the sums and the build, use the wheel builder on the website.
Michael
Book it inSpokes in the shop
See them allNot sure which fits? Send us your bike's make, model and year and we'll tell you.
Get the printable PDF
The same guide on two A4 pages, to print for the workshop or keep on your phone. Leave your email and we'll send the link. It unlocks every guide in the library on that device.
Already unlocked on this device? Download the PDF
This guide is general advice for home mechanics. Bikes and parts vary, so always follow the maker's instructions and torque settings for your parts. If you're not sure, or the job needs tools you don't have, ask a qualified mechanic. Travers Bikes can't be responsible for work you carry out yourself. Nothing here affects your legal rights. Sizes checked 17/11/2026 against Park Tool's and Sheldon Brown's spoke length guides.


